27
Safety
or the push block into its holder when not in use.
13. The sawing of angles/wedges is only permitted if an appropriate
auxiliary stop (cross stop) is used.
14. Replace the table insert if it is worn – pull out the power plug –
15. If necessary, wear suitable personal protection equipment. This
could consist of:
a. Ear muffs to prevent the risk of damaging your hearing;
b. A breathing mask to avoid the risk of inhaling hazardous dust;
c. Always wear gloves when handling saw blades and rough
materials. Whenever practicable, saw blades must be carried in a
container;
16. Use only the transport devices to move the equipment. Never use
the guards for handling or moving the equipment.
17. While you are moving the machine it is best to cover the top part
of the blade, e.g. with the guard.
18. Give these safety instructions to all persons who work on the
machine.
19. Do not use this saw to cut fire wood.
20. Do not use this saw to cross-cut roundwood.
21. The machine is equipped with a safety switch to prevent it from
being switched on again accidentally after a power failure.
22. If you need to use an extension cable, make sure its conductor
cross-section is big enough for the saw’s power consumption.
Minimum cross-section: 1.5 mm².
23. If you use a cable reel, the complete cable must be pulled off the
reel.
24. Never load the machine so much that it cuts out.
25. Always press the workpiece firmly against the saw table.
26. Make sure that off-cuts do not catch on the saw blade crown. Risk
of catapulting!
Layout_F_TS_2000_1_UK_SPK7.indd 27Layout_F_TS_2000_1_UK_SPK7.indd 27 23.06.2020 14:29:3623.06.2020 14:29:36
To Next Page
Loading...
Need help?
General
