41
Operation
part which is to be cut off.
• Always push the cross stop forward until the workpiece is cut all
the way through.
1. Adjust the cross stop (
15
) to the desired position (see the
section “Cross stop”). If you also want to tilt the saw blade (
31
)
slide the cross stop into the right guide groove (
6
) to prevent
your hand and the cross stop from making contact with the saw
blade guard (
2
).
2. Lower the saw blade guard down to the saw table (
1
).
When sawing, the saw blade guard will be pressed up by the
workpiece.
3. Press the workpiece firmly against the cross stop.
4. Switch on an extraction system and then the table saw.
5. Push the cross stop and the workpiece toward the blade in order
to make the cut.
6. Switch off the table saw and the vacuum extraction system.
7. Leave the off-cut piece on the saw table until the saw blade is
back in its position of rest.
Cutting particleboard
To prevent the cutting edges from cracking when working with
particleboards, do not set the saw blade (
31
) more than 5 mm
higher than the thickness of the workpiece.
After sawing
1. Switch off the table saw by pressing the red operating switch 0 (
43
).
2. Wait until the saw blade (
31
) has reached a complete standstill
and then take the workpiece off the saw table (
1
).
3. Disconnect the table saw from the mains power supply by pulling
the power plug out of the socket.
4. Allow the table saw to cool down completely.
Layout_F_TS_2000_1_UK_SPK7.indd 41Layout_F_TS_2000_1_UK_SPK7.indd 41 23.06.2020 14:29:3723.06.2020 14:29:37
To Next Page
Loading...
Need help?
General
