EasyManuals Logo

ALDI FERREX F-TS 2000-1 User Manual

ALDI FERREX F-TS 2000-1
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
42
Operation
Removing jammed material
Risk of injury!
There is a risk of serious injuries if the table saw is handled
improperly.
Switch off the table saw immediately and pull the power plug out
of the socket if the saw blade has got jammed in the workpiece or
if any other blockages occur.
Wear protective gloves, do not touch the saw blade with bare
hands.
Changing the saw blade (Fig. 29)
Risk of injury!
Always disconnect the power plug before you change the saw
blade!
There is a risk of serious injuries if the table saw is handled
improperly.
Wear protective gloves, do not touch the saw blade with bare hands.
1. Remove the two fastening screws and remove the table insert
(
5
) from the saw table. When you do so, always check the table
insert:
Replace the table insert immediately if it is damaged or is no
longer flush with the saw table.
2. Make sure that the angle adjustment facility of the saw blade is
set to 45°. If necessary, adjust the angle adjustment facility as
described in the section “Setting the cutting angle.
Layout_F_TS_2000_1_UK_SPK7.indd 42Layout_F_TS_2000_1_UK_SPK7.indd 42 23.06.2020 14:29:3723.06.2020 14:29:37

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ALDI FERREX F-TS 2000-1 and is the answer not in the manual?

ALDI FERREX F-TS 2000-1 Specifications

General IconGeneral
BrandALDI
ModelFERREX F-TS 2000-1
CategorySaw
LanguageEnglish

Related product manuals