not leaking.
flames, lit cigarettes, or hot objects.
in a confined area.
WARNING: Ensure the engine is switched off while undertaking
this task.
1. Remove the fuel tank cap (2) by rotating in an anticlockwise direction.
2. Remove the fuel tank inlet filter (27) and ensure it is clean and free of debris.
Check the level of fuel is sufficient.
3. If the fuel tank inlet filter (27) was removed to check the fuel level, ensure it
is replaced back before adding fuel.
4. To add fuel, pour the unleaded fuel from an approved fuel container into the
fuel tank (1). As fuel expands, DO NOT FILL to the lip of the tank. Maximum
fill is to the top of the fuel tank inlet filter (27) rim.
5. Replace fuel tank cap (2) turning in a clockwise direction to lock.
Checking the Engine Oil
The engine of this generator is NOT filled with oil when unpacked.
Prior to starting the engine ensure the oil tank is filled with SAE 10W-30
4 stroke oil. For the first time fill the engine should be filled with 600ml
of SAE 10W-30 oil.
NOTE: Damage to the engine is not covered under warranty if the engine is
run with insufficient oil.
1. Before checking or refilling oil, be sure the generator is put on a stable and
level surface, ensuring the engine has been switched OFF.
2. Remove the oil filler cap (15) by rotating the cap in an anti-clockwise
direction, and wipe all oil residue off the oil dipstick (15) with a clean rag.
Re insert the oil filler cap / dipstick (15) and thread the cap fully in position.
Then remove the oil filler cap / dipstick (15) by rotating in an anti clockwise
direction and view the oil level on the oil dipstick (15).
Engine Oil
To Next Page
Loading...
Need help?
General