4
Pack contents / parts
Congratulations on the purchase of your Workzone® Titanium 3500W Inverter
Generator with Pure Sine Wave. When you open your packaging, first remove all items
and check there are no parts damaged or missing. If you find anything wrong, do not
operate the product until the parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
NOTE: This is a 4 stroke Inverter Generator.
The engine MUST be filled with 600ml of SAE 10W-30 BEFORE starting.
Fresh unleaded fuel must be used in this unit. Do NOT use Ethanol based fuels.
Do NOT mix oil with fuel.
NOTE: First time users or inexperienced operators pay particular attention to
the operation of the Generator, including details of starting and stopping and
correct use of the Generator on pages 19-23, as well as the maintenance
instructions on pages 26-31.
Intended use of the 3500W Inverter Generator with Pure Sine Wave
NOTE: This product is for private domestic DIY use only.
It is not suitable for commercial or trade use.
This product is suited for home, camping and caravan applications & domestic house
hold mains failure back up. It will allow you to power outdoor lights, power tools,
home appliances including sensitive electronic equipment, including televisions
and computers.
NOTE: For sensitive equipment like computers, sound systems, televisions,
microwaves etc, it is highly recommended to have a surge protector connected
to the generator.
NOTE: This petrol Generator is NOT suitable for:
* Marine applications, and should never be used on board water craft
* Continuous off the grid power
Contents of carton
1 x 3500W Inverter Generator
1 x Instruction Manual
1 x Warranty Card & details
1 x Quick Start Guide
1 x 10mm Tube Spanner
1 x 21mm Spark Plug Tube Spanner
1 x Multi Size Spanner
1 x Double Ended Screwdriver (Phillips and flat)
2 x Wheels (+ 2 x assembly bolts, nuts, spring
washer & flat washer)
4 x Feet (+ 4 x assembly hex head screws, nuts,
spring washer & flat washer)
1 x Wheel Foot (+ 1 x assembly hex head screw)
1 x Handle Assembly (+ 2 x assembly screws
& nyloc nuts)
2
To Next Page
Loading...
Need help?
General