• If Locate 2 is located before Locate 1 on the tape and Auto 2>1 is enabled, the
Auto 2>1 LED will flash to indicate that Locate 1 must precede Locate 2.
• If Auto 2>1 is on and you set Locate 2 while the tape is playing, the transport will
store the new Locate 2 point and return immediately to the Locate 1 point.
• If Auto 2>1 is turned off while ADAT is returning to the Locate 1 point, the
transport will still find the Locate 1 point.
4.1D The Auto Play Function
Enabling Auto Play (its LED will be lit) causes ADAT to automatically enter Play
mode whenever any autolocation function is complete, although this can be
overridden by the transport controls. This button can be pressed at any time.
Note:
A 'one time" auto play function can be initiated by pressing PLAY once after initiating
a locate search and before the locate point is reached. The PLAY LED will flash until
the locate point is reached, then enter play mode. Pressing PLAY twice will cancel
the locate search and initiate play mode.
4.1E Record, Then Audition Your Part
If you locate to Locate 1, enable Auto 2>1 and Auto Play, then start recording,
recording will occur and continue until ADAT passes through the Locate 2 point.
ADAT will then punch out, rewind back to Locate 1, and play back what you just
recorded so you can audition your part. Upon reaching Locate 2, ADAT will again
return to Locate 1. If you want to redo the part, press Stop, go into record mode, and
start the process all over again or use the punch-in footswitch after it has located
back to Locate 1.
4.2 FOOTSWITCH CONTROLLED AUTOLOCATION
The rear panel Locate/Play/LRC jack can be used with any momentary, single-
pole/single-throw footswitch. During power-up, ADAT checks the footswitch to
determine whether it is a normally open or normally closed type, and calibrates itself
accordingly. If you use a footswitch and its operation seems “reversed,” make sure it
is firmly plugged into the jack, then turn ADAT off, wait a few seconds, and turn it on
again. It will recalibrate itself to work with the footswitch.
The Locate/Play footswitch has three functions.
• If the transport is currently stopped, pressing the Locate/Play footswitch is
equivalent to pressing the Play button.
To Next Page