Diagnosis
34
After touch: Press hard any key on the keyboard until the value reaches “127”, release your hand, the
value will reach 0 and it will switch to the next controller “Acc”. (The display will temporarily show “Acc”,
then show the accelerator value.)
Accelerator: Stand the keyboard up vertically and the value will reach “127”, then put the keyboard flat
on a table, the value will reach 0 and the display will show “PAS”.
Notes:
z If the display reports an error by showing “Err”, the test will stop and wait until the problem is fixed.
z Once starting the ADC test, you cannot switch to another test until all items are passed in the ADC
test.
To Next Page
Loading...
