8128 SIP Strobe Light (G2)
Manually Override Time
For testing purpose, you may also override the time setting.
Note: This time value will be lost at power down, or overwritten if NTP is currently
active. Time and date are used only for logging purposes and are not typically
required.
Advanced Settings Tab – Provisioning
Note: It is recommended that Provisioning Mode be set to Disabled if this feature is
not in use. This will prevent unauthorized re-configuration of the device if DHCP is
used.
Provisioning allows installers to pre-configure 8128 SIP Strobe Light units prior to
installation on a network. It is typically used for large deployments to save time and
ensure consistent setups.
The device can be provisioned via the Auto mode (where all three DHCP options
(Option 66/160/150) will be automatically checked for an active provisioning
Document 90-00100C
11/27/2019
Page 41
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
Loading...
