8128 SIP Strobe Light (G2)
Terminal Block Reset
The reset relay terminal on the back can be used to reset the 8128 SIP Strobe
Light at time of power up. To return all the settings to the factory default for the
8128, wait until the LED flashes, then connect the reset terminals and hold until
the 8128 LED begins a double flash pattern. Release the reset connection and
allow the unit to complete its boot process.
A reset will set all configuration options to factory default including the
password.
Document 90-00100C
11/27/2019
Page 9
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
Loading...
