2 Remove the jumper plug from the password jumper (pin number three and four)
and place it on the CMOS jumper (pin number five and six).
1 jumper plug 2 CMOS jumper (pin number
five and six)
3 password jumper (pin number
three and four)
3 Replace the video-card fan.
4 Replace the processor fan.
5 Replace the top cover.
6 Replace the base cover.
7 Turn on your computer.
A message is displayed to confirm that the CMOS settings are reset and default
BIOS setup has been loaded.
8 Press F1 to continue and wait till the operating system is completely loaded.
9 Shut down your computer.
90
To Next Page
Loading...
