4. Connect the keyboard-backlight cable to the keyboard-contoller board and close the latch to secure the cable.
5. Connect the keyboard cable to the keyboard-controller board and close the latch to secure the cable.
6. Connect the keyboard-controller board cable to the system board and close the latch to secure the cable.
Next steps
1. Install the
battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
System board
Removing the system board (NVIDIA GeForce 3060/3070 Ti/3080 Ti graphics
card)
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the memory.
4. Remove the
2230 solid-state drive or 2280 solid-state drive in slot one, whichever applicable.
5. Remove the 2230 solid state drive or 2280 solid-state drive in slot two, whichever applicable.
6. Remove the wireless card.
7. Remove the rear-I/O cover.
8. Remove the battery.
About this task
NOTE: This procedure only applies to computers shipped with a NVIDIA GeForce 3060/3070 Ti/3080 Ti graphics card.
The following image indicates the connectors on your system board.
1. Display cable
2. Alien head LED-cable
50
To Next Page
Loading...
Need help?
General