60 | Replacing the Display Assembly
Replacing the Display
Assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Place the display assembly in position and replace the screws that secure the display
assembly to the computer base.
2 Route the display cable, camera cable, infrared cable, wirelessHD card cable, and
Mini-Card antenna cables through the routing guides on the palm rest assembly.
3 Connect the display cable to the connector on the system board.
4 Tighten the captive screws that secure the display cable to the system board.
5 Connect the camera cable and infrared cable to the respective system board
connectors.
Postrequsites
1 Connect the wirelessHD card cable to the connector on the wirelessHD card. See
"Replacing the WirelessHD Card" on page 54.
2 Connect the Mini-Card antenna cables to the Mini-Card. See "Replacing the
Mini-Card" on page 51.
3 Replace the keyboard. See "Replacing the Keyboard" on page 48.
4 Replace the center control cover. See "Replacing the Center Control Cover" on
page 44.
5 Replace the compartment door. See "Replacing the Compartment Door" on page 15.
6 Replace the battery pack. See "Replacing the Battery Pack" on page 13.
7 Follow the instructions in "After Working Inside Your Computer" on page 11.
To Next Page
Loading...
Need help?
General