64 | Removing the Palm Rest Assembly
Removing the Palm Rest
Assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Prerequsites
1 Remove any installed card or blank from the 9-in-1 Media Card Reader.
2 Remove the battery pack. See "Removing the Battery Pack" on page 12.
3 Remove the compartment door. See "Removing the Compartment Door" on page 14.
4 Remove the screws that secure the palm rest assembly to the computer base.
5 Remove the center control cover. See "Removing the Center Control Cover" on
page 41.
6 Remove the keyboard. See "Removing the Keyboard" on page 45.
1 screws (5)
To Next Page
Loading...
