Alinco DR-438 - Parameter Setting Mode; Channel Lockout and Name Editing; Reverse TX;RX

19
7
Busy Channel Lockout
BCLO is to disable transmitting while RX signal is received. Once the
channel is busy and you press PTT, the radio will beep as warning and
get back to receiving.
Press and hold
1.
key for over 2
seconds to enter setting menu.
Press
2.
/ key to choose No.10
menu, LCD displays "LOCK--OFF".
Turn selector knob to select the desired
3.
setting.
BU: Enable

BCLO, Carrier lockout, transmitting is inhibited when
current channel receives a matching carrier.
RL: Enable

BTLO, transmitting is inhibited when current channel
receives a matching carrier but dis-matching CTCSS/DCS.
OFF:

Busy channel lockout is disabled. It can transmit in any
receiving status.
Press
4.
key to conrm and exit.
In memory-mode, press and hold
1.
key
for over 2 seconds to enter setting menu.
Press
2.
/ key to choose No.11
menu, LCD displays cursor and ashing.
Turn Main Dial to select the desired letter, press
3.
key to conrm
selected letter and enter into next edition, press
to return
forward edition.
After edition, press
4.
key to exit.
Reverse TX/RX
Editing Channel NAME
In Frequnecy display (VFO)mode, this menu is not available.
TX frequency turns to RX frequency & RX frequency changes to TX
frequency. CTCSS/DCS setting is respected also.
Press and hold
1.
key for over 2 seconds to enter setting menu.
Press
2.
/ key to choose No.12
menu, LCD displays "REV—OF".
Turn Main Dial to select the desired
3.
setting.
ON:Enable Frequency Reverse
OFF:Disable Frequency Reverse.
Press
4.
key to set and exit.
Turn Main Dial to select the desired
3.
setting.
On:In current channel, press PTT to
transmit
OFF:In current channel, press PTT is
invalid.
4
. Press
key to conrm and exit.
(Available only in Memory mode)
PARAMETER SETTING MODE