27
10
Steering-wheel etc.
[UX1260]
DC power cable
Battery
Optional alarm cable
[UX1259]
Anti-theft Alarm
Optional extention cable (if necessary)
A loud alert beep sounds when the unit is about to be removed in an
improper manner.This function is useful when the unit is installed in a
vehicle.
Setting: Connect the DC cable direct to the battery as shown.
Operation:
Connect the optional alarm cable to the DATA jack on the front
1.
panel as shown WHILE POWER IS ON. Secure the other end
of the cable to an object that stays fixed in the vehicle. Use an
optional extension cable if necessary.
Turn off the unit by pressing the PWR key. The alarm is now active.
2.
To operate, turn on the unit rst then remove the cable while power
3.
is ON.
By removing or cutting the cable before turning on will sound alarm. To
turn off the alarm, press PWR key to turn off the power. The alarm is
canceled and turns on normally when PWR key is pressed next time.
To Next Page
Loading...
