ALLEN & HEATH ML3000 - Page 31

AP4721 ML3000-SLV2 Fitting Notes 4
AL4686
Fig.6
CN3
Step 9: Fit the 26way harness AL4686 to the
SYS-LINK IN card CN3 Fig.6
Step 10: Fit the SYS-LINK IN card into the
console using the 4 D-type fixing nuts (supplied
fitted to the assembly). Use a 5mm nut spinner
Fig.7
Step 11: Fit the free end of 26way harness
AL4686 to the male connector socket on the
main console IDC buss harness Fig.8 and Fig.9
Step 12: Check that all harnesses are securely
aligned and fitted. Check your work and remove
any dirt or debris from within the console. Re-fit
the base panel.
Step 13: Connect power and test the SYS-LINK
system for correct operation. Refer any queries
to Allen & Heath technical support.
AL4686
CN3
Fig.8
INPUT A INPUT BAUDIO LINK INPUT
INSERT
DIRECT OUT
IN
INSERT
DIRECT OUT
IN
INSERT
DIRECT OUT
IN
INSERT
DIRECT OUT
IN
INSERT
DIRECT OUT
IN
INSERT
DIRECT OUT
IN
INSERT
DIRECT OUT
IN
INSERT
DIRECT OUT
IN