Publication 1769-UM009B-EN-P - May 2002
Quick Start for Experienced Users 2-5
Start system.
a. Apply power.
b. Download your program and put the controller into Run
mode.
c. During a normal start-up, the Module and Network LEDs turn
on solid green.
d. If the LEDs turn red or flash, see Table 8.1 Troubleshooting
the LEDs and Numeric Display on page 8-2. If the condition
persists, contact your local distributor or Rockwell
Automation for assistance.
Monitor the module status to check if the module is operating
correctly.
Module status is reported by the LEDs and numeric display on
the front of the module. The information is also stored in the
module’s input data file, so these bits can be used in your
control program to flag an error.
EXAMPLE
Chapter 3
Installation and Wiring
Chapter 8
Troubleshooting
EXAMPLE
Chapter 8
Troubleshooting
Allen-Bradley Drives
To Next Page
Loading...
