Publication 1769-UM009B-EN-P - May 2002
6-4 Using the 1769-SDN Scanner Module with CompactLogix Controllers
5. Right click on the 1769-ADN and choose Properties. The
following screen appears:
6. Click on the I/O Bank 1 Configuration tab, then choose
upload when prompted. The actual 1769-ADN I/O layout
appears. From this screen you can configure the I/O modules in
the 1769-ADN system by simply clicking on the slot number box
associated with each I/O module.
For this example, only the two analog modules need to be
configured. The graphical user interface makes configuring these
modules very straight forward. Refer to the Compact I/O Analog
Modules User Manual, publication 1769-UM002A-EN-P for
additional information concerning the analog modules.
TIP
Only analog and specialty modules are
configurable. Discrete I/O modules, power
supplies, and end caps are not configurable.
To Next Page
Loading...
