110 Rockwell Automation Publication 8720MC-RM001K-EN-P - September 2018
Appendix A Specifications
Technical Specifications
The following table contains technical specifications for the 8720MC-RPS
units.
Attributes 8720MC-RPS065 8720MC-RPS190
Number of Units
Connected in Parallel
(1)
Single Unit Two Units in Parallel Three Units in Parallel Single Unit Two Units in Parallel Three Units in Parallel
Capacity of Motor to
be Applied (kW)
37 75 110 125 250 375
Input
Rated capacity of the power
supply (kVA)
45 90 135 152 304 457
Input power factor
(2)
0.95 or higher
Power supply
(3)
324 to 506V AC +10/-15%, 50/60 Hz +/-5%
Rated current, nom (A
rms
) 65 130 195 190 380 570
Current, max 1.0 min (A
rms
) 98 196 294 285 570 855
PWM carrier frequency (kHz) 5, 10 (standard), and 15 5, 10 (standard), and 15
Output
Rated output capacity (kVA) 45 90 135 133 266 399
Voltage 750V (standard)
Continuous output current (A
DC
) 64 128 192 190 380 570
Current, max 1.0 min (A) 96 192 288 285 570 855
Bus capacitor (μF) 1960 1960 x 2 1960 x 3 5600 5600 x 2 5600 x 3
Protection functions Overcurrent, overload, overvoltage, low voltage, and phase loss.
Output signals RDY signal, FR signal, instantaneous power loss signal, and main magnetic contactor reference contact.
Monitor display (with four-character
seven-segment status indicator
Input current, input power supply voltage, DC bus voltage, power and load ratio.
Input signals RUN signal, RESET signal, and answer-back signal of the main magnetic contactor.
Environmental
Place of installation In a control cabinet (kept away from corrosive and dangerous gas).
Ambient
Operating -10…50 °C (14…122 °F)
Storage -40…65 °C (-40…149 °F)
Heat dissipation (kW) 1.1 1.1 x 2 1.1 x 3 4.0 4.0 x 2 4.0 x 3
Relative humidity 5 to 95% (non-condensing)
Elevation
• Up to 1,000 m (3,300 ft) without derating output power
• For every 300 m (1,000 ft) above 1,000 m (3,300 ft), derate the output power 4%
• Above 1,500 m (5,000 ft), contact Rockwell Automation
Vibration Less than 1G (25 Hz)
Shock Less than 2G
Weight kg (lb) 13.5 (29.7) 13.5 (29.7) x 2 13.5 (29.7) x 3 39 (86.8) 39 (86.8) x 2 39 (86.8) x 3
(1) For units connected in parallel, derating is required proportionally to the fluctuation (dispersion) of inductances of AC line reactors connected to phases.
(2) At the rated current of the 8720MC-RPS units.
(3) Applies to 400V rms AC (or 200V rms AC). If you use the unit continuously at a voltage lower than stated, derating is required.
To Next Page
Loading...
