Allen-Bradley 8720MC-RPS065 - Apply Power to the 8720 MC-RPS Unit; Verify the Parameter of the Unit Selection

Rockwell Automation Publication 8720MC-RM001K-EN-P - September 2018 79
8720MC-RPS Startup and Operation Chapter 6
Apply Power to the 8720MC-RPS Unit
Apply power to the 8720MC-RPS unit.
The initial display shows SELF, with all
six status indicators ON, which indicates
that the unit is performing power-up self-
diagnostics.
After the diagnostics are complete
(approx. 0.5 seconds), the operation panel
is in Monitor mode. The display shows
the input current value, and the A status
indicator turns ON. This display shows
that the input current is 0 Amp.
Verify the Parameter of the Unit Selection
1. Press PRG.
The operation panel changes to
Program mode and the
PROGRAM status indicator turns
ON. The display shows U.–––,
which indicates that you can access
the user parameters.
2. Press .
The display shows F.–––, which
indicates that you can access the
Factory parameters.
3. Press ENT.
The display shows the first Factory
parameter (F.000).
4. Press .
The display shows the second
Factory parameter (F.001).
RST
PRG
ENT
READYREADY
FAULTFAULT
PROGRAMPROGRAM kWkW
V
A
RST
PRG
ENT
READYREADY
FAULTFAULT
PROGRAMPROGRAM kWkW
V
A
RST
PRG
ENT
READYREADY
FAULTFAULT
PROGRAMPROGRAM kWkW
V
A
RST
PRG
ENT
READYREADY
FAULTFAULT
PROGRAMPROGRAM kWkW
V
A
RST
PRG
ENT
READYREADY
FAULTFAULT
PROGRAMPROGRAM kWkW
V
A
RST
PRG
ENT
READYREADY
FAULTFAULT
PROGRAMPROGRAM kWkW
V
A