Need help?Do you have a question about the Allen-Bradley Guardmaster 440C-CR30 and is the answer not in the manual?
General| Product Type | Safety Relay |
|---|---|
| Supply Voltage | 24V DC |
| SIL Rating | SIL 3 |
| PL Rating | PL e |
| Category | Category 4 |
| Stop Category | 0 |
| Enclosure | IP20 |
| Mounting | DIN Rail |
| Number of Safety Channels | 2 |
| Max Switching Current | 6A |
| Connection Type | Screw terminals |
| Safety Inputs | 2 |
| Auxiliary Outputs | 1 |
| Response Time | 20 ms |
| Operating Temperature | -25...55 °C |
| Standards | EN ISO 13849-1, IEC 62061 |
| Dimensions (H x W x D) | 22.5 x 114 mm |
| Agency Approvals | CE |
| Function | Monitoring and control of safety devices |
| Safety Outputs | 3 safety outputs (2 semiconductor, 1 relay) |
Provides a general overview of the document and its purpose in guiding users through the safety relay setup.
Defines key terms and abbreviations essential for understanding the manual's content.
Lists resources and building blocks available for the Connected Components Accelerator Toolkit.
Provides information on further documentation and related Rockwell Automation products.
Outlines essential prerequisites and preparation steps required before starting the safety relay setup.
Lists all necessary hardware and software components for successfully setting up the safety relay.
Presents a flowchart detailing the procedures for configuring the 440C-CR30 safety relay.
Details the physical connection process using a USB cable between the safety relay and the computer.
Guides users through the process of setting up communication parameters for the safety relay.
Directs users to a supplementary quick start guide for detailed software configuration.
Specifies the prerequisites and essential steps before commencing the system validation process.
Lists all required hardware and software components for performing system validation.
Provides a procedural overview of the steps involved in validating the system.
Explains the system architecture and various connection methods for the devices.
Details the configuration of communication ports on the Micro800 controller.
Guides users on setting up communication parameters for the PanelView 800 HMI terminal.
Describes the physical connections required between the PanelView, controller, and safety relay.
Instructs on how to download the control program to the Micro800 controller.
Details the process for setting a static IP address on the PanelView 800 terminal.
Guides on transferring the HMI application from the computer to the PanelView 800 terminal.
Covers understanding screens, verifying configurations, performing resets, and troubleshooting issues.
To Next Page
