Publication 1734-UM009A-EN-P - June 2002
2-6 Configuring Your RS-232 ASCII Module
Setting the RS-232 ASCII
Module’s Parameters
After adding the module to the network, you must configure the
module for use.
1. Configure the modules by right-clicking on the module and
choosing properties, or double-clicking on the module.
You will see a pop-up screen with a series of tabs. Each tab provides
options view or edit. The tabs are shown below and on the following
pages.
IMPORTANT
This chapter shows configuration in the online
mode. Changes set in this mode take effect when
you download to the individual module.
These are the tabs you click on to
view the options.
To Next Page
Loading...
