Allen-Bradley POINT I/O PROFIBUS 1734-APB - Page 33

Publication 1734-UM005B-EN-P - June 2001
Configuring the POINT I/O System 3-9
Available parameters are module dependant. However, some
parameters are common for all module types. These parameters are:
Extended Diagnostics, Fault Action and Idle Action.
Parameter Data in hexadecimal.
To configure a module, click
on the “Module” button.
Select the module you wish to
configure.
(Click “OK” to continue.)
Module Parameters
From the list, select the
parameter you wish to
change.
(Click “OK” to continue.)
Example: To change the
“Range” parameter, select
“Range” in the list and click
“OK.”
Select the value you wish to
use, and click “OK.”
Allen-Bradley HMIs