Programming and Parameters 3-39
UTILITY
HIM Ref Config
192 [Save HIM Ref]
Enables a feature to save the present frequency reference value issued by the
HIM to Drive memory on power loss. Value is restored to the HIM on power up.
193 [Man Ref Preload]
Enables/disables a feature to automati-
cally load the present “Auto” frequency
reference value into the HIM when “Man-
ual” is selected. Allows smooth speed
transition from “Auto” to “Manual.”
Default:
Options:
0
0
1
“Disabled”
“Disabled”
“Enabled”
MOP Config
194 [Save MOP Ref]
Enables/disables the feature that saves the present MOP frequency reference at
power down or at stop.
195 [MOP Rate]
Sets rate of change of the MOP
reference in response to a digital input.
Default:
Min/Max:
Units:
1.0 Hz/s
30.0 RPM/s
0.2/[Maximum Freq]
6.0/[Maximum Freq]
0.1 Hz/s
0.1 RPM/s
Drive Memory
196 [Param Access Lvl]
Selects the parameter display level.
Basic = Reduced param. set
Advanced = Full param. set
Fan/Pump = Reduced fan/pump set
Adv Fan/Pump = Full fan/pump set
(1)
Standard Control drives v3.001 & up.
Default:
Options:
0
0
1
2
3
4
“Basic”
“Basic”
“Advanced”
“Reserved”
“Fan/Pump”
(1)
“Adv Fan/Pump”
(1)
File
Group
No.
Parameter Name & Description
See page 3-2 for symbol descriptions
Values
Related
xxx 1xxxxxxxxxxxx
10 01234567891112131415
1 =Save at Power Down
0 =Do Not Save
x =Reserved
Bit #
Factory Default Bit Values
At Powr Down
0xx 0xxxxxxxxxxxx
10 01234567891112131415
1 =Save at Power Down
0 =Do Not Save
x =Reserved
Bit #
Factory Default Bit Values
At Powr Down
At Stop
Vector
Vector
Vector
To Next Page
Loading...
