Rockwell Automation Publication 20C-PM001F-EN-P - March 2012 105
History of Changes Appendix C
The information below summarizes the changes to the Programming Manual -
PowerFlex 700H Adjustable Frequency AC Drive, publication 20C-PM001,
since the February 2004 release.
Change
Updated “How Parameters are Organized” to include parameters 358 and 359
New value 2 - “Invert” added to parameter 178 [Sleep Wake Mode]
Updated parameter 211 [Drive Alarm 1] for new Gate Disable function
Updated parameter 212 [Drive Alarm 2] for new Gate Disable function
Updated parameter 214 [Start Inhibits] for the new Gate Disable function
Updated parameter 229 [Alarm 1 @ Fault] for new Gate Disable function
Updated parameter 230 [Alarm 2 @ Fault] for new Gate Disable function
Updated parameter 238 [Fault Config 1] for new Gate Disable function
Updated parameter 259 [Alarm Config 1] for new Gate Disable function
Added parameter 358 [20C-DG1 Remove] for Gate Disable function
Added parameter 359 [20C-DG1 Status] for Gate Disable function
Updated the “Parameter Cross Reference” charts to reflect the addition of parameters 358 and 359
Added a “Solution” for Faults 15, 16, 47, and 65
Added Fault 31 “IGBT Temp HW”
Updated the “Fault & Alarm Descriptions” table to reflect the addition of new faults 59 “Gate Disable” and 60 “Hrdwr
Term”
Updated the “Fault/Alarm Cross Reference” tables to include the new items
Added additional “Technical Support” information
Updated the “Sleep/Wake Mode” function to reflect the new “Invert” mode
To Next Page
Loading...
