Preliminary Information
About the Control
This control is an advanced, programmable computer that allows
the owner to control most machine features by pressing a se-
quence of keypads. Refer to Control Identification.
The control allows the owner to retrieve audit information and
run diagnostic tests. Refer to Entering the Manual Mode for a full
list of features.
IMPORTANT: In the event of a power failure, the control
will not have to be reprogrammed. It is designed with a
memory system that will remember how it was pro-
grammed until the electrical power is restored.
IMPORTANT: It is extremely important that the machine
has a good ground connection and that all mechanical
and electrical connections to the control are made be-
fore applying power to or operating the machine.
Glossary of Terms
The following are a few terms and abbreviations to learn. These
are referred to throughout the instructions.
Display – This term refers to the window area of the control that
displays words and values.
LED (Light Emitting Diode) – This term refers to the lights next
to the keypads and status words of the control.
Power Fail Recovery
If a cycle is in progress and the power fails, the cycle status is
saved in memory. When the power recovers, the dryer will re-
sume into the previously active cycle (if so programmed by the
owner), by pressing the START pad. If the power failure occurs
while the control is in a fatal error mode, it will return to Start
Mode upon recovery.
Preliminary Information
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
20 Part No. 70579901ENR9
To Next Page
Loading...
