Display Identification
Light Emitting Diodes (LEDs)
LIGHT EMITTING DIODES (LEDs) are used to indicate the
chosen cycle and cycle status. See below for information on each
LED.
CYCLE LED
(High, Medium, Low, No Heat)
Cycle LED will remain lit the entire cycle.
REVERSING LED (reversing models only)
Any time a cycle or cycle step is set for reversing, the REVERS-
ING LED will be lit.
Four 7-Segment Digits
The 7-Segment Digits are used to display the time remaining in a
cycle, error messages and descriptive codes. During diagnostic
testing, these digits will display descriptive codes and values (as
described in How to Enter Manual Programming Mode).
Display Identification
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
24 Part No. 70579901ENR9
To Next Page
Loading...
