Installation must conform with local codes or, in the absence of
local codes, with:
In the U.S.A., installation must conform to the latest edition of
the American National Standard Z223.1/ NFPA 54 “National
Fuel Gas Code” and Standard ANSI/NFPA 70 “National Electric
Code.”
In Canada, installation must comply with Standards CAN/CSA-
B149.1 or Natural Gas and Propane Installation Code and CSA
C22.1, latest edition, Canadian Electric Code, Part I.
In Australia and New Zealand, installation must comply with the
Gas Installations Standard AS/NZS 5601 Part 1: General Installa-
tions.
WARNING
FOR YOUR SAFETY, the information in this manual
must be followed to minimize the risk of fire or ex-
plosion or to prevent property damage, personal in-
jury or death.
W033
WARNING
• Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
• WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Clear the room, building or area of all occu-
pants.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s in-
structions.
• If you cannot reach your gas supplier, call the
fire department.
• Installation and service must be performed by a
qualified installer, service agency or the gas sup-
plier.
W052
IMPORTANT: Information must be obtained from a lo-
cal gas supplier on instructions to be followed if the
user smells gas. These instructions must be posted in
a prominent location. Step-by-step instructions of the
above safety information must be posted in a promi-
nent location near the tumble dryer for customer use.
IMPORTANT: The installer must fully test the tumble
dryer after installation and demonstrate to the owner
how to operate the machine.
WARNING
To reduce the risk of electric shock, fire, explosion,
serious injury or death:
• Disconnect electric power to the tumble dryer be-
fore servicing.
• Close gas shut-off valve to gas tumble dryer be-
fore servicing.
• Close steam valve to steam tumble dryer before
servicing.
• Never start the tumble dryer with any guards/
panels removed.
• Whenever ground wires are removed during serv-
icing, these ground wires must be reconnected to
ensure that the tumble dryer is properly ground-
ed.
W002R1
WARNING
• Installation of unit must be performed by a quali-
fied installer.
• Install tumble dryer according to manufacturer’s
instructions and local codes.
• DO NOT install a tumble dryer with flexible plastic
venting materials. If flexible metal (foil type) duct
is installed, it must be of a specific type identified
by the appliance manufacturer as suitable for use
with tumble dryer. Refer to section on connecting
exhaust system. Flexible venting materials are
known to collapse, be easily crushed, and trap
lint. These conditions will obstruct tumble dryer
airflow and increase the risk of fire.
W752R1
The following information applies to the state of Massachusetts,
USA.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
3 Part No. 70579901ENR9
To Next Page
Loading...
