Installation
34
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT Part No. 70458101ENR7
Models
Prepurge
Time (seconds)
Trial for Ignition
(seconds)
Reset Lockout
Condition By:
Models Starting
3/11/13
Non-CE and non-
Australian
1 10
(attempts to ignite 3
times)
Open loading door
Models starting
3/11/13 through
7/31/13
Australia 18 10 025, 030, 035, 055:
Press reset button on
rear of machine
T30, T45: Press lighted
reset button in rear
contactor box
Models starting 8/1/13 Australia
Models Starting
1/1/14
CE
23 23 For models with EO,
RE, RU or UO control
suffixes: Press start on
control keypad.
For models with all
other control suffixes:
Press and hold ignition
control reset button.
If the tumble dryer does not meet ANY of the listed requirements, remove tumble dryer from use. Refer to Removing Tumble Dryer
from Service section.
Required for CE Models Only
Once machine is installed, please be sure to complete the
following items:
• Review and verify machine operation with customer.
• Leave all literature and a signed Declaration of Conformity
with customer.
• Review machine warranty information with customer.
• Apply warning sticker on front panel of machine, in language
appropriate to country of sale (included in literature packet).
Installing CE Gas Drying Tumble Dryer
General Information
This information is to be used when installing gas tumble dryers
in countries and/or on gases different than the machine’s factory
configuration. Tumble Dryers are supplied from the factory
for operation on Natural Gas 1000 Btu/cu. ft. (8914 kcal/m
3
),
or L.P. Gas 2500 Btu/cu. ft. (22,250 kcal/m
3
), with natural
gas group H/E, designation G20 and L.P. gas group B/ P,
designation G30. To install machines in any other country, or on
any other gas, requires some level of modification.
Machines are built in two different configurations:
• Natural Gas – regulated/governor
• Liquefied Petroleum (L.P.) Gas – not regulated/no governor
Serial plates supplied from the factory are configured for GB/
IE/PT/ES/IT/GR/LU/CH/BE. These instructions pertain to the
situations when the country of use or gas supply is different than
that on the serial plate. If applicable, peel off the appropriate
country sticker (included with machine) and apply it to the serial
plate over the existing country information.
These instructions are only valid if the following country code
is on the appliance: GB/IE/PT/ES/IT/GR/LU/CH/BE. If this
code is not present on the appliance, it is necessary to refer
to the technical instructions which will provide the necessary
information concerning the modification of the appliance to the
condition of use for the country.
Before installation, check that the local distribution conditions,
nature of gas and pressure, and the adjustment of the appliance
are compatible.
Table 1 describes the different gases that are available in
different CE countries, and how the machines need to be
configured to operate with those gases. In the CE, there are
Natural Gas configurations that do not allow for machine
regulation and L.P. Gas configurations that must be regulated.
For L.P. Gas, third family B/P at 50 mbar (5 kPa), order
To Next Page
Loading...
