Operating Instructions
Part No. 70458101ENR7
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 71
Figure 33
NOTE: The window display will flash. Press STOP/
RESET twice (within three seconds) to end the
cycle and reset the control to idle status. To restart
the tumble dryer, CLOSE door and press START
pad.
IMPORTANT: If the loading door or lint panel door
is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and START pad
must be pressed.
4. When the cycle is complete, open door and remove the
laundry.
WARNING
To prevent the risk of fire, remove laundry
immediately in case of power failure.
W779
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle
is complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.
LED OPL Control
RE Control Suffix
1. Press the Up or Down keypad to change cycles.
To customize a cycle, refer to the Programming Manual.
2.
Press START ( ) to start selected cycle.
IMPORTANT: If the loading door or lint panel door
is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the START (
) pad must be pressed.
3. When the cycle is complete, open door and remove laundry.
WARNING
To prevent the risk of fire, remove laundry
immediately in case of power failure.
W779
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle
is complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.
After an hour the machine enters delayed tumble
and will tumble for two minutes every hour for up
to 18 hours or until the door is opened.
S Models H Models
Figure 34
To Next Page
Loading...
