80 801683
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
35. CABINET TOP
Front Control Washers
a. Remove control panel. Refer to Paragraph 30
or 32.
b. Remove two screws holding front of cabinet
top to top front edge of control cabinet front.
Refer to Figure 22.
c. If area or space permits, lift cabinet top to a
vertical position by hinging it on the rear
hinges.
NOTE: To avoid damage to hinges, be sure to
support cabinet top with a small chain or something
similar. Refer to Figure 23.
d. Remove cabinet top from washer by removing
nuts and carriage bolts holding cabinet top and
hinges to control cabinet. Refer to Figure 24.
e. Carefully lift cabinet top off washer and set out
of the way to prevent damage.
Figure 22
Speed
Nuts
Screws
with
Lockwasher
Figure 23
Cabinet
Top
Wire, Rope
or Chain
FLW1680S
To Next Page
Loading...
