Alliance Laundry Systems HWFB61WN1102 - Page 86

84 801683
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
r. Lift front of cabinet top slightly and pull
forward to disengage from rear hinges.
s. Pull top forward far enough to permit
disconnecting ground wires from top rear
corner gusset of washer cabinet.Refer to
Figure 30.
t. Disconnect wires from mixing valve solenoids
at rear of washer.
NOTE: Refer to appropriate wiring diagram when
rewiring mixing valve solenoids.
u. Carefully lift cabinet top off washer and set on
protective padding.
Figure 29
H204SE3A
B
L
E
A
C
H
S
O
F
T
E
N
E
R
MAX
M
AX
Door
Switch
Door
Latch
Switch
Attaching
Screws
Door
Latch
Switch
Door
Switch
Wires
Wire
Harness
Front Panel
Attaching Screws
Dispenser
Drawer