© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Vending
512680
32
Slide Extension
(Coin Slide Models with Standard Capacity
Metercase Only)
NOTE: Models with high capacity metercase
require a coin slide with a switch installed on it.
1. Remove slide extension parts from parts
accessories bag included in unit.
2. If installing a Greenwald coin slide, position
extension lever (to be installed on extension
bracket) with arm that has one star facing down.
Refer to Figure 35.
3. If installing a Monarch or ESD coin slide,
position lever with arm that has two stars facing
down. Refer to Figure 35.
4. Install extension lever with rounded corner
facing away from extension bracket using bolt,
one or two flat washers (shims) (use number of
washers included in kit) and nut. Refer to Figure
36. Make sure washers are flat against bracket.
5. Torque nut between 2 and 2.26 Nm (18 and 20
inch-pounds), or tighten nut firmly.
6. Install extension spring in bracket hole and hole
in upper arm of lever. Refer to Figure 36.
7. Bend loops closed after installation.
8. Check to make sure the lever swings freely.
TLW2088N
Figure 35
Greenwald
Coin Slide
Monarch or
ESD Coin Slide
One Star
Two Stars
TLW2089N
Figure 36
Extension Bracket
Spring
Bolt
One or Two
Flat Washers (Shims)
Nut
Extension Lever
Star(s) Facing Down
Loops
Rounded Corner
To Next Page
Loading...