EasyManua.ls Logo

Alliance Laundry Systems SDE907 - Step 4: Set Fabric Selector; Step 5: Insert Coin(S) or Card; Step 6: Start Dryer; Indicator Lights

Alliance Laundry Systems SDE907
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
41
512680
Step 4: Set Fabric Selector
Select HIGH TEMP, MED TEMP, LOW TEMP or
DELICATES by pushing touchpad.
NOTE: Always follow manufacturers care label
instructions.
Figure 56
Step 5: Insert Coin(s) or Card
To Insert Money
Insert coin(s) in coin slot. Check pricing as seen on
digital display.
Figure 57
To Insert Card
Insert card into opening.
Figure 58
If Additional Time Feature is turned on, additional
dryer time may be purchased at cycle start or while
dryer is running.
Remove knits when slightly damp because overdrying
may cause shrinkage. Do not tumble dry knit woolens.
Step 6: Start Dryer
To start dryer, push START pad.
To stop dryer at any time, open the door. To restart the
dryer, close door and push START pad.
Cycle is completed when time remaining reaches
00 minutes.
Figure 59
Indicator Lights
START
START is lit whenever the dryer is not in a cycle, the
full vend price has been satisfied and the dryer door is
closed. When the START pad is pressed, the cycle
will begin or resume.
DRYING
DRYING is lit to indicate that one of the heated cycles
(HIGH TEMP, MED TEMP, LOW TEMP or
DELICATES) is currently in operation. DRYING will
turn off at the end of a heated cycle or when the COOL
DOWN cycle begins.
COOL DOWN
COOL DOWN is lit whenever the COOL DOWN
portion of a heated cycle is active. It is also lit when no
heat is programmed for a cycle in operation.
DRY1926N
W387I
DRY1927N
DRY1926N
DRY1928N
DRY1928N

Table of Contents

Related product manuals