Installation
52
Unpacking the Switch
To unpack the switch, perform the following procedure:
1. Remove all components from the shipping package.
Note
Store the packaging material in a safe location. You must use the
original shipping material if you need to return the unit to Allied
Telesyn.
2. Place the switch on a level, secure surface.
3. Make sure the following hardware components are included in
your switch package. If any item is missing or damaged, contact
your Allied Telesyn sales representative for assistance.
❑ One AT-8000 Series Fast Ethernet Switch
❑ Two mounting brackets
❑ Eight flathead Phillips screws
❑ AC power cord (AC switches only; Americas, EC, Australia, and
UK only)
❑ Management cable
❑ Documentation CD
❑ Warranty card
To Next Page
Loading...
