AT-S63 Management Software Features Guide
Section VII: Routing 345
Local Interface
The local interface is used with the enhanced stacking feature. It is also
used with remote management of a switch with a Telnet or SSH client, or a
web browser. The local interface does the following:
With an enhanced stack, it designates on the master switch the
common VLAN and subnet that interconnects the switches of the
stack. The master switch uses the local interface to send out its
broadcast packets when searching for the other switches in a stack.
With remote management, it designates the VLAN and subnet from
where the remote management workstation will access the switch. The
switch uses the local interface to watch for the management packets
from the remote workstation and to send packets back to the remote
station.
For example, assume you wanted to remotely manage a switch that had
four subnets and four interfaces named VLAN4-0, VLAN11-0, VLAN12-0,
and VLAN12-1, and the remote workstation was reaching the switch
through the subnet of the VLAN11-0 interface. You would need to
designate the VLAN11-0 interface as the local interface on the unit.
A switch can have only one local interface.
For background information on remote management of the switch, refer to
the Starting an AT-S63 Management Session Guide. For background
information on enhanced stacking, refer to Chapter 3, “Enhanced
Stacking” on page 77.
To Next Page
Loading...
Need help?
General
