Chapter 38: TACACS+ and RADIUS Protocols
448 Section IX: Management Security
Supported Platforms
Refer to Table 112 and Table 113 for the AT-9400 Switches and the
management interfaces that support the TACACS+ and RADIUS
protocols.
Table 112. Support for the TACACS+ and
RADIUS Protocols
Switch Supported
Layer 2+ Models
AT-9408LC/SP Yes
AT-9424T/GB Yes
AT-9424T/SP Yes
Basic Layer 3 Models
AT-9424T Yes
AT-9424T/POE Yes
AT-9424Ts Yes
AT-9424Ts/XP Yes
AT-9448T/SP Yes
AT-9448Ts/XP Yes
AT-9400Ts Stack
Yes
1
1. Stacks do not support the TACACS+
protocol.
Table 113. Management Interfaces for the TACACS+ and RADIUS Protocols
Switch or Stack
Standard
Command
Line
AlliedWare
Plus
Command
Line
Menus
Web
Browser
Stand-alone Switch Yes Yes Yes Yes
AT-9400Ts Stack Yes Yes
Yes
1
1. You can use the web browser interface to configure RADIUS accounting on a stack, but you
cannot use the interface to enter the IP addresses of the RADIUS servers.
To Next Page
Loading...
