Chapter 3: Installing the Switch
44
The chassis may be heavy and awkward to lift. Allied Telesis
recommends that you get assistance when mounting the chassis in
an equipment rack. E28
1. Review “Choosing a Site for the Switch” on page 38 to verify the
suitability of the site for the switch.
2. Place the unit upside down on a level, secure surface. See Figure 11.
Figure 11. Turning the Switch Upside Down
3. Using a flat-head screwdriver, remove the rubber feet from the bottom
of the switch. See Figure 12.
Figure 12. Removing the Rubber Feet
4. Turn the switch over.
5. Attach the handles to the brackets as shown in Figure 13.
Figure 13. Attaching the Handles to the Brackets
To Next Page
Loading...
