508067-01 Issue 2016 Page 43 of 75
11. Pull out the panel frame while pushing the hook
through a clearance between the panel frame and the
heat exchanger.
12. Release the 5 hooks of the vertical blades, then pull
the vertical blades rightward and remove it.
13. Remove 1 screw of the display board.
14. Rotate the display board in the direction shown in the
right picture.
Electrical Parts
NOTE: When handling electrical parts use anti-static
gloves.
NOTE: Remove the front panel (see Step 1 on page 41)
before disassembling electrical parts.
1. Cut the ribbon by a shear, then pull out the coil
temperature sensor (T2).
2. Remove one xing screw of the electronic control box
and two screws used for the ground connection.
Ribbons T2 Sensor
3. An upward force is maintained until the cover of
electronic control box is removed.
To Next Page
Loading...