44 - English - Translated from the original language Manual 6-1624970M - rev. 1 - 11/01/2023
Cancellation of a single transmitter learned
With this parameter you can erase a single transmitter already learned, using its memory location. If this value is not known, refer
to the function "Display memory position of a learned transmitter".
Follow these steps to cancel:
• Access the parameter by holding down the MENU button for 3 seconds.
• When the display displays the value " 0 " release the button and use the UP and DOWN buttons to set the memory position
of the remote to be erased.
• Confirm by holding down the MENU button for 3 seconds.
• The display will display the message " CLr " to indicate the correct deletion.
• If the memory location is empty the message " Err " will appear.
• You can delete more than one remote control in the same session. To exit the function, press the MENU button briefly.
PARAMETER VALUES DEFAULT
TrC
Deletion of all radio memory
With this parameter it is possible to reset the radio memory.
This will erase ALL the transmitters learned.
To perform total cancellation follow these steps:
• Access the parameter by holding down the MENU button for 3 seconds.
• When the display displays the value " 0 " release the button.
• Press the MENU button and hold it until the countdown ends and the display displays " don ".
• The procedure was successfully completed.
PARAMETER VALUES DEFAULT
TrF
To Next Page
Loading...
