PC Configuration
To connect:
• Check the checkbox Allow me to connect to the selected wireless network, even though it
is not secure.
• The Connect button will then be available. Click the Connect button, and wait a few
seconds for the connection to be established.
If using WEP Data Encryption
If WEP data encryption has been enabled on the Wireless-N Broadband Router, Windows will
detect this, and show a screen like the following.
Figure 29: WEP (Windows XP)
To connect:
• Enter the WEP key, as set on the Wireless-N Broadband Router, in the Network Key field.
• Re-enter the WEP key into the Confirm Network key field.
• Disable the checkbox Enable IEEE 802.1x authentication for this network.
• Click the
Connect button.
If this fails, click the Advanced button, to see a screen like the following:
43
To Next Page
Loading...