UM
150
User’s Manual
31
UM
150
User’s Manual
3) If this USB device does cause harmful interference with radio or television
signals (determine this by turning the USB device
off and on), attempt to correct
the interference by trying one or more of the following:
• Reorient or relocate the antenna.
• Increase the distance between the USB device and receiver.
• Connect the USB device into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
4) This USB device does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the interference causing equipment standard
entitled “Digital Apparatus”, ICES-003 of the Department of Communications.
5) If you have purchased this product under a United States Government contract,
it shall be subject to restrictions as set forth in subparagraph (C)(1)(ii) of
Defense Federal Acquisitions Regulations (DFARs) Section 252.227-7013
for Department of Defense contracts, and as set forth in Federal Acquisitions
Regulations (FARs) Section 52.227-19 for civilian agency contracts or any
successor regulations. If further government regulations apply, it is your
responsibility to ensure compliance with such regulations.
6.4 Safety Precautions
1) Data transmission and reception cannot be guaranteed because of the nature
of wireless communications. Data can be delayed, corrupted or lost during
transmission. Even though it is quite rare that significant data delay or loss occurs
if the USB device is used in a normal manner, this USB device should not be
used in cases that data transmission or reception failure could result in damage
of any kind to the user or another party, including but not limited to personal
injury, death or loss of personal property. UTStarcom bears no responsibility for
damages or losses of any kind resulting from delays or errors in data transmission
using the USB device, or for failure of the USB device to transmit or receive such
data.
2) Do not use this USB device in areas where blasting is in progress, where
explosive atmospheres may be present, near medical equipment, life support
equipment, or any equipment which may be susceptible to any form of radio
interference. Turn off this USB device in these areas, since it can transmit signals
that could interfere with this equipment.
To Next Page
Loading...