Alltion (Guangxi) Instrument Co., Ltd.
Safety Caution | AM-5000 User's Manual
including the User's Manual for accessories and other system components.
Keep the User's Manual in order to facilitate the operator to read at any time.
Please observe all symbols and labels of the instrument!
The modification and repair of this instrument can only be performed by the ALLTION
service personnel or others authorized by ALLTION, The maintenance method is seen
"AM-5000 Surgical Microscope Service Manual", if involving electrical maintenance, you
can apply to us to the diagrams, components list and other materials that necessary.
Do not place any container filled with liquid over the instrument. Confirm that no liquid
can penetrate into the instrument.
Using the original power adapter is necessary. Other adapters will decrease the safety of the
device.
No modification of this equipment unless authorized by the manufacturer.
Although the equipment conforms to the intent of the standard IEC 60601-1-2 in relation to
electromagnetic compatibility, electrical equipment may produce interference. If interference
is suspected, move equipment away from sensitive device or contact us.
Do not store or use the instrument in a damp room. Do not expose the instrument in the
place with splashing, dropping or water mist.
When the instrument is generating smoke, electric spark or a strange noise, please
immediately cut off power supply of the instrument. Do not use this instrument until it has
been repaired by our service agent.
Please note that local regulations take precedence over the requirements of the above
mentioned criterions. If you have any enquiry, please contact the local ALLTION dealer.
Requirements on Installation
The installation of the product will be completed by our service representative or by
professional personnel authorized by us. Please make sure that the following operational
requirements have been met:
All the safety-related mechanical connections (please find the Manual for details) are
properly connected and all screws have been tightened.
All wires and plugs work normally.
The adopted power wires meet the design requirements of this instrument.
Please do not place the equipment in a difficultly operation position.
Operating Requirements
Please pay special attention to the PROMPT symbols on the instrument (especially
warning sign).
Avoid to watch the light source of the microscope directly, for example, the objective
lens of the microscope.
Do not disassemble and assemble the binocular head barrel and objective lens during
use to prevent falling and injuring the patient.
Do not disassemble or assemble the supporting components during use to prevent the
Support system from being out of balance, damaging the components or hurting the
patient.
To Next Page
Loading...
