Allworx Phone Model 9212/9212L User Guide
+1 866 ALLWORX * +1 585 421 3850 Page 5
www.allworx.com
Version: J Revised: March 2, 2017
2.2 Adjust the Phone Angle
The phone base angle adjusts for easier phone screen reading.
To adjust the phone base angle:
1. Unplug the phone from the PoE or the power supply. Remove the handset from the hook and
lay the phone face down on a soft surface.
2. Hold the base with the fixed tabs facing the bottom of the phone. Select one of the three
available positions to connect the base to the phone. The set of holes at the bottom of the
phone provides the steepest angle.
3. Place the fixed tabs in the preferred holes on the back of the phone. Rotate the phone base
upwards until the flexible tabs click into place.
To remove the base:
1. Remove the handset from the hook and lay the phone face down on a soft surface.
2. Press down on the flexible tabs and rotate the base towards the phone bottom until the fixed
tabs easily lift out of the holes.
2.3 Volume Adjustment
The volume of the incoming ring, handset, speaker phone, and the headset is adjustable.
To adjust the incoming call volume:
1. Locate the phone volume bar. Do not lift the handset or turn on speaker phone.
2. Press the volume bar – (decrease) or + (increase) to adjust the incoming ring audio level. The
phone plays the audio tone.
To adjust all other volumes:
1. Pick up the handset or turn on the speaker phone or headset. Locate the phone volume bar. The
phone screen displays which audio path is being adjusted.
2. Press the volume bar to – (decrease) or + (increase) the audio level.
To Next Page
Loading...
