To Next PageTo Next Page
Need help?Do you have a question about the Alpha-InnoTec Luxtronik and is the answer not in the manual?
General| Brand | Alpha-InnoTec |
|---|---|
| Model | Luxtronik |
| Category | Controller |
| Language | English |
Crucial safety and handling instructions before operating the unit.
Explains the meaning of various symbols used in the manual.
Lists items included in the scope of supply for installed and wall controls.
Guides for assembling and installing the control unit on the wall.
Details different models of the control unit included in the scope of supply.
Details different motherboard types equipped in the controller.
Instructions for mounting and installing the external temperature sensor.
Instructions for mounting and installing the domestic hot water sensor.
Guide for initial setup and commissioning of the heat pump controller.
Procedure for updating or downgrading the controller software.
Safety instructions and procedures for dismantling the unit.
Step-by-step guide for initial setup and configuration of the heat pump.
Allows saving and resetting configuration settings made during commissioning.
Restores system settings to those stored during initial commissioning.
Explains the emergency operating mode and its activation conditions.
Steps to select the program area for system configuration.
Setting the automatic or manual mode for the cooling function.
Adjusting temperature setpoints for cooling operation.
Configuring operational parameters for the cooling function.
Details how cooling is activated based on temperature settings.
Conditions and prerequisites for enabling the active cooling function.
Navigating to select the desired program area.
Retrieving various system information and status data.
Displays the status of various digital inputs and their functions.
Displays the status of various controller outputs and their functions.
Shows accumulated run times for different system components.
Displays stored error messages and their timestamps.
Shows accumulated operating hours for various components.
Records instances of disconnections or interruptions.
Displays information about the heat pump type, software versions, and operation mode.
Shows recorded heat quantities for heating and domestic hot water.
Displays data if the heat pump is integrated into a building management system.
Displays smart settings if an individual room controller is connected.
Lists errors that occurred during operation with timestamps.
Displays inverter operating parameters for service purposes.
Lists events that occurred during operation with timestamps.
Controls access levels for system settings and parameters.
Instructions for accessing preset operating programs.
Setting various temperature parameters for heating and cooling.
Configuration for utilising hot gas for higher temperatures.
Setting operational priorities for the heating system.
Settings for controlling mixing circuit 1, including cooling.
Configuration related to domestic hot water and circulation pumps.
Settings for air defrost functionality and pump optimization.
Managing data access and configuring brine/flow sensors.
Settings for heating limit, parallel operation, and remote maintenance.
Defines the time for heating circulation pump shutdown.
Configuration of circulation pump operation for optimal efficiency.
Managing startup parameters and backing up error logs.
Configuration for the RBE room control unit accessory.
Configuration and activation of additional heat generators.
Configuration of the inverter for compressor frequency control.
Enables individual configuration of outputs on the controller board.
Settings for low-noise operation of the heat pump.
Configuration of pump flow lead times for circulation pumps.
Configuration for smart operation via mobile devices.
Utilisation of Smart Grid functionality for electricity tariff optimisation.
Adjusting heating and hot water settings based on Smart Grid signals.
Wiring diagrams for Smart Grid connections.
Details the automatic heating of screed floors with timed temperature stages.
Configuring screen language and system date/time.
Procedures for initiating the screed heating program.
Steps to manually stop the screed heating program.
Configuring the heat pump based on its type and installed components.
Accessing and managing logged data.
Adjusting display contrast, web server, and remote maintenance.
Procedure for acknowledging and handling fault messages.
Interpreting the status of LEDs on the controller board.
Specifications, connections, and electrical data for the unit.
Specifies the measuring ranges for various sensors used by the controller.
Provides an overview of defrost cycles, air defrost, and flow maximum parameters.
