Need help?Do you have a question about the Alpha-InnoTec Luxtronik 2.0 and is the answer not in the manual?
General| Type | Heat Pump Controller |
|---|---|
| Compatibility | Alpha-InnoTec Heat Pumps |
| Display | LCD |
| Connectivity | Ethernet, USB |
| Operating Voltage | 230V AC |
| Protection Class | IP20 |
| Communication | Modbus |
| Operating Temperature | 0°C to +50°C |
Essential information for safe and correct handling of the unit.
Explanation of danger, warning, caution, and attention symbols.
Details on the control unit's display, buttons, and menus.
Explains the navigation screen and its symbols.
Configuring heating mode, temperature, and heating curves.
Configuring domestic hot water mode and target temperature.
Configuring cooling mode and target temperature.
Accessing and utilizing the service program area for diagnostics.
Procedures for initial setup and operation of the unit.
Setup and usage of the remote maintenance function.
Specifies the correct application and purpose of the unit.
Conditions under which the manufacturer is not liable for damage.
Warnings regarding electric shock and qualified personnel requirements.
Guidelines on using accessories, avoiding pump shutoff, and frost protection.
Information on the low maintenance needs of the regulator.
How to get technical assistance and warranty information.
Details of components included in the installed and wall-mounted units.
Steps for installing the internal control unit.
Instructions for mounting the wall control unit.
Guidance on establishing electrical connections for the installed control.
How to install the external temperature sensor correctly.
Step-by-step guide for safely removing the buffer battery.
Meaning of the status indicators around the rotary pushbutton.
Detailed explanation of the rotary pushbutton's navigation and selection capabilities.
Procedure for changing the language of the display.
Steps for first-time commissioning and switching on the unit.
Understanding the information shown on the heating mode screen.
How to access and select the heating program.
Configuring the operational mode for the heating function.
How to access and select the domestic hot water program.
Configuring the operational mode for domestic hot water preparation.
Conditions required for enabling the cooling program area.
How to access and select the cooling program.
Configuring the operational mode for cooling.
How to access and select the service program.
Retrieving information such as temperatures and inputs.
Displaying readings from various temperature sensors.
Detailed settings for domestic hot water services.
Configuring defrost cycles and air defrost parameters.
Settings for pump operation optimization and data access authorization.
Setting up brine pressure and flow monitoring.
Adjusting heating curves for flow setpoint calculation.
Configuring the unit as a DHCP server for direct network connection.
Configuring the unit as a DHCP client for network connection.
Restrictions and requirements for parallel operation of heat pumps.
Environmental and electrical requirements for installation.
Details on USB, Ethernet interfaces and protection class.
Table showing resistance values for temperature sensors.
Table listing measuring ranges and default values for sensors.
To Next Page
