7
We reserve the right to make technical changes.
83052300eUK © ait-deutschland GmbH
Maintenance of the unit
The heating and heat pump regulator does not require regu-
lar maintenance.
Customer service
For technical assistance, contact your qualied technican or
the manufacturer’s local service partner.
Operating instructions for your heat pump,
Appendix, customer service, addresses for service
NOTICE
“TOutside min” and TOutside max” are not faults
that require the customer service to be phoned.
The heat pump starts again automatically when the
outside temperature lies within the use limits
Warranty / Guarantee
For warranty and guarantee conditions, please refer to the
purchase documents.
NOTICE
Please contact your dealer concerning warranties
and guarantees.
Disposal
When decommissioning the unit, always comply with applica-
ble laws, directives and standards for the recovery, recycling
and disposal of materials and components of cooling units.
page 15, „Dismantling“
Scope of delivery
NOTICE
Function-critical temperature sensors (return, inlet,
hot gas) are installed in the heat pump and are not
part of the scope of supply of the heating and heat
pump regulator.
The heating and heat pump regulator is supplied in two vari-
ants. The variant supplied is dependent on the device type of
the heat pump to the controlled.
Installed control scope of supply
In the case of devices for internal mounting, the control card
of the heating and heat pump regulator is integrated in the
relevant device as an “installed control”. The “installed con-
trol” scope of supply is included in the scope of supply of the
device for internal mounting.
•
Heating and heat pump regulator,
consisting of control card (with terminals) and operating
element (with status display, screen and “rotary pushbut-
ton”).
•
External sensor for the surface mounting.
•
operating manual.
•
“Brief description of the heat pump control”.
NOTICE
Please fasten brief description in the vicinity of the
device.
Wall control scope of supply
In the case of devices for external mounting, the control
card of the heating and heat pump control is not integrated
in the relevant device. The “wall control” scope of supply is
not included in the scope of supply of the device for exter-
nal mounting.
•
Heating and heat pump control for surface mounting,
consisting of control card (with terminals), housing
and operating element (with status display, screen and
“rotary pushbutton”).
•
Wall mounting materials (drill template, screws, dowels
for solid masonry).
To Next Page
Loading...
Need help?
General
