Alpha-InnoTec Luxtronik 2.0 - Calling Up Error Memories; Calling Up Disconnections

37
We reserve the right to make technical changes.
83052300eUK © ait-deutschland GmbH
callIng up error memorIes
In the “Service Information” menu select the menu
eld “Error memory”…
The screen changes to the menu “Service Information
error memory”…
1 Error code
Meaning of the error codes: page 72, „Error Diag-
nosis / Error messages“
2 Date of the resulting error
3 Time of the resulting error
NOTICE
Maximum the last ve resulting errors are displayed.
Return to menu “Service Information”.
callIng up dIsconnectIons
In the “Service Information” menu select the menu
eld “Disconnections”…
The screen changes to the menu “Service Information
disconnections”…
1 Date of the disconnection
2 Time of the disconnection
3 Disconnection code
Error hp = heat pump fault
err.inst. = system fault
m.o. 2hg = mode of operation second heat
generator
El. Sup. bl = el. sup. blockade
Defr. air. = air defrost (only L/W devices)
TPLmax = temperature limits of application
maximum
TPLmin = temperature limits of application
minimum
(in reversible LWD possible shut-
down due to frost protection in
cooling mode - evaporation too
long below 0°C)
Low lim = lower limit of application
no requ. = no request
NOTICE
Maximum the last ve disconnections are displayed.
Return to menu “Service Information”.