Alpha-InnoTec Luxtronik - Screed Heating Program Setup; Screed Heating Program Overview; Screen Display and Time Settings

35Subject to technical amendments without prior notice | 83055400iUK – 2.1 | ait-deutschland GmbH
SCREED HEATING PROGRAM
The screed heating program is used for automatic heating of
screed oors. To do so, the system runs through the ten steps of
supply target temperatures in the menu for the for the respective
assigned time intervals. As soon as all stages have been complet-
ed, the screed heating program ends automatically.
The outdoor temperature is xed at -10 °C during the screed heat-
ing program in order to avoid various shutdown causes or to
guarantee the full functionality of an additional heat generator.
NOTE
Values of the factory setting correspond to the specications
of some screed manufacturers, but can be changed on site .
IMPORTANT
Always check values of the factory setting or desired val-
ues in respect to whether they correspond to the manu-
facturer specications for the screed which is to be heated.
Setting temperatures and time intervals
Example:
Procedure repeat for the table lines “Flow2“ to “Flow10“.
Klemmenplan SG-Ready HZ-I/O
-
-X4 -X3-2
SG1
SG2
Legend:
Equipement
A1
A3
SG1
SG2
IN3
IN4
UK
Function
Controller board; Attention: I-max = 6,3A/230VAC
Sub-distribution unit internal installation
Smart Grid activation 1
Smart Grid activation 2
831210
123 45678
12 8
A
B
C
D
E
F
A
B
C
D
E
F
Blatt
Bl.
1
1
3 4567
AIT
831210
Klemmenplan
ait-deutschland GmbH
L1 L1 L1 L
2
2
IN1 IN2 IN3A1A2A1A2
IN4 IN5
A3
A1
Änderung Datum
Datum
Bearbeiter
Geprüft
NormName
09.10.2015
Pfleger
R.
Klemmenplan SG-Ready HZ-I/O
-
-X4
-X3-2
SG1
SG2
Legende:
Betriebsmittel
A1
A3
SG1
SG2
IN3
IN4
DE
Funktion
Reglerplatine; Achtung: I-max = 6,3A/230VAC
Unterverteilung Hausinstallation
Smart Grid Ansteuerung 1
Smart Grid Ansteuerung 2
831210
123 45678
12 8
A
B
C
D
E
F
A
B
C
D
E
F
Blatt
Bl.
1
1
3 4567
AIT
831210
Klemmenplan
ait-deutschland GmbH
L1 L1 L1 L
2
2
IN1 IN2 IN3A1A2A1A2 IN4 IN5
A3
A1
Änderung Datum
Datum
Bearbeiter
Geprüft
NormName
09.10.2015
Pfleger
R.
LWCV • LWDV • LW(A)V • LW(A)HV • LWAV+ • LWP
SELECTING LANGUAGE OF THE SCREEN DISPLAY
 Part 1 of the controller manual, section “Basic Information on
the operation“.
DETERMINING DATE AND TIME
 Part 1 of the controller manual, section “Basic Information on
the operation“.