10
Subject to change without notice | 83057000jUK – Translation of the original operating manual | ait-deutschland GmbH
5.2 Storage
directly before installation.
Store unit protected against:
Moisture/damp
Frost
Dust and dirt
5.3
NOTE
The module box can be removed for transport
( “Dismantle the module box”, page 12).
Notes on safe transport
The housing with the unit components and the module
box are heavy ( “Technical data / Scope of supply”,
to property if the housing with the unit components
falls or overturns or if the module box falls.
The housing with the unit components and
module box must be transported and installed by
several persons.
Secure the housing with the unit components
during transport. Carry the module box by the
carrying lugs.
of the unit.
Wear cut resistant protective gloves.
The hydraulic connections are not designed for
mechanical loads.
Do not lift or transport the unit by the hydraulic
connections.
If the module box is tilted by more than 45°, compressor
oil runs into the cooling circuit.
Do not tilt the unit with installed module box by
more than 45°.
alternatively with a handcart.
Transport the unit to the place of installation
NOTE
and dismantling the housing panels.
1.
damage the unit.
2.
way according to local regulations.
3.
front panel in the place of installation.
Dismantle housing panels for transport with
handcart or carrying the unit
To avoid damage to the housing panels:
1. Undo 2 screws at the bottom of the front panel.
Lift up the front panel and put down in safe place.
2. Undo 3 screws at the right panel.
Lift up the side panel and put down in safe place.
3. Undo 3 screws at the left panel.
Lift up the side panel and put down in safe place..
To Next Page
Loading...
Need help?
General
